HENAN GNEE NEW MATERIAL CO., LTD
86-372-5055135

Aluminum Plate Thickness for Curtain Wall

May 27, 2025

1. Conventional thickness range‌
‌Standard plate‌: The common thickness of curtain wall aluminum plate is ‌1.5mm~3.0mm‌, and the typical grade is ‌3003-H24‌, which meets the wind pressure resistance strength ≥2.5kPa (corresponding to 30m high buildings).
‌Super high-rise scene‌: When the building height exceeds 100m, the recommended thickness is increased to ‌3.0mm~4.0mm‌, and the density of reinforcing ribs is increased to cope with dynamic wind loads.

2.Aluminum Sheet Application Recommendations

Application Part Recommended Thickness Key Parameters
High-rise Exterior Wall 2.5 – 3.0 mm Tensile strength ≥130 MPa, Elongation ≥15%
Podium / Low-rise 2.0 – 2.5 mm Surface flatness ≤0.1 mm/m, Suitable for bending processing
Interior Decoration 1.5 – 2.0 mm Weight ≤4.5 kg/m², Helps reduce structural load-bearing costs

3. Performance adaptation adjustment‌
‌Relationship between wind pressure and thickness‌:
When the basic wind pressure is ≥0.6kN/m², the thickness needs to be increased by 0.2mm for every increase of 0.1kN/m² (such as coastal typhoon area projects).
The spacing between reinforcing ribs should be ≤400mm (3.0mm board) or ≤300mm (2.5mm board) to prevent local deformation.
‌Weather resistance requirements‌:
When the thickness of fluorocarbon sprayed aluminum plate (two coatings and three baking processes) is ≥2.5mm, the neutral salt spray test life is ≥1000 hours.

4. Process and material matching‌
‌Alloy selection‌:
‌3003-H24‌: Balanced comprehensive performance, suitable for 90% curtain wall scenes.
‌5052-H32‌: For special-shaped plates that require frequent stamping and shaping, the thickness can be reduced by 0.2mm (strength compensation).
‌Surface treatment restrictions‌:
The lower limit of the thickness of anodized aluminum plate is 2.0mm (to prevent deformation during oxidation).
5. Design specification reference‌
‌Deflection control‌: The center deflection of the plate should be ≤L/180 (L is the short side length), and the thickness of the 4.0m span aluminum plate must be ≥3.0mm.
‌Economic optimization‌:
Plates with a width of ≤1300mm can avoid additional over-width processing fees, and the recommended grid size is 1200mm×2000mm.
Selection process diagram
‌Input parameters‌: building height, wind pressure value, surface treatment process
‌Preliminary selection of thickness‌: match the foundation thickness according to the height (1.5/2.0/2.5/3.0mm)
‌Strength verification‌: adjust the thickness according to the wind pressure value and calculate the density of the reinforcement
‌Process adaptation‌: verify the compatibility of the stamping/spraying/oxidation process and thickness

Aluminum Plate Thickness for Curtain Wall1060 O 1100 H14 Curtain Wall Aluminum Plate