What Is 1050 Aluminum Bar?
1050 aluminum bar is manufactured from industrially pure aluminum containing at least 99.5 percent aluminum. It belongs to the 1000 series, a family of non-heat-treatable alloys that gain strength only through cold working. The high purity gives 1050 excellent formability, long-term corrosion resistance, and very good electrical and thermal conductivity, making it a versatile material for industrial, electrical, and architectural components. It is commonly supplied as round bar, square bar, flat bar, and other profiles, and is available under designations such as EN AW-1050A in European standards and 1050 in Chinese GB/T standards.
Key Characteristics of 1050 Aluminum Bar
Formability is the outstanding feature of 1050: the bar can be machined, bent, and formed with low risk of cracking, which suits production of fittings, terminals, and shaped components. Corrosion resistance comes from the natural oxide film that protects the surface in atmospheric and many industrial environments. Conductivity is high because of the low alloy content, so 1050 bar is frequently selected for electrical busbars, connectors, and heat-transfer parts. The material is also lightweight, roughly one third the density of steel, and easy to weld and braze with appropriate procedures.
Common Tempers for 1050 Bar
Because 1050 cannot be strengthened by heat treatment, the temper determines its mechanical condition. O temper is fully annealed and very soft, suited to heavy forming. H14 is strain-hardened to a half-hard state, providing a practical balance of strength and workability for general machining and fabrication. Harder tempers such as H16 and H18 give increased stiffness and surface hardness at the expense of ductility. The right temper should be matched to the machining and forming operations planned for the part.
Typical Applications of 1050 Aluminum Bar
In the electrical industry, 1050 bar is used for busbars, terminals, and conductive fittings where conductivity matters. In general engineering, it appears in spacers, flanges, frames, and machined components that need light weight and corrosion resistance. In architecture and decoration, its clean appearance and ease of anodizing make it suitable for rails, trims, and fittings. It is also used in heat-transfer equipment and in food and chemical handling where high purity and clean surfaces are valued.
Procurement and Specification Points
When ordering 1050 aluminum bar, specify the alloy and temper, the profile (round, square, or flat), diameter or cross-section, length, and applicable standard such as EN 573-3 and EN 485-2 or the equivalent national standard. Confirm the required mechanical properties, surface condition, and tolerance class, and request a mill test certificate if the parts will be used in certified assemblies. Because 1050 and the slightly higher purity 1060 behave very similarly in most applications, availability and cost often decide between them.
FAQ
Q: Can 1050 aluminum bar be heat treated to increase strength?
No. 1050 is a non-heat-treatable alloy, so strength is controlled by cold working and temper selection rather than heat treatment.
Q: Is 1050 bar suitable for electrical applications?
Yes. Its high aluminum purity gives good electrical conductivity, and it is commonly used for busbars, terminals, and conductive fittings.
Q: What is the difference between 1050 and 1060 aluminum bar?
Both are commercially pure grades. 1060 guarantees a minimum of 99.6 percent aluminum versus 99.5 percent for 1050, giving slightly higher purity and conductivity; in practice the two are often interchangeable.
Q: Can 1050 bar be anodized?
Yes. The high purity of 1050 produces a clean, uniform anodic film, which makes it a good choice for decorative and protective finishes.
Q: What sizes are commonly available?
Round, square, and flat bar are supplied in a wide range of diameters and cross-sections, with custom lengths and machining available on request.







